Redsn0w will take you through the necessary steps: Step 16: You will now need to put your iPhone into the DFU mode. Follow the instructions and click on the Next button to move to the next screen: Step 15: You will now be prompted to plug your iPhone to the computer and switch it OFF again. Step 14: Then click on the Just Boot button. Step 12: You still need to rerun Redsn0w to boot tethered. Your iPhone will reboot once again (which could take approximately 5 minutes). Step 11: The rest of the process will take place on your iPhone, wait for it to complete. Click on the Ok and then Quit button to exit the application. Step 10: You will now be notified once the jailbreaking process is complete. Step 9: Your iPhone will reboot again and Redsn0w will now begin uploading the new RAM disk and kernel. iPhone 3GS users can also select Enable battery percentage option. Make sure Cydia is selected and click on the Next button to continue. Step 8: You will now be prompted to select the jailbreak options. Step 7: Redsn0w will now start preparing the jailbreak data. Please remember to release the Home button. (c) Now release the Power button while keeping the Home button pressed until Redsn0w detects the device: (b) Now simultaneously hold the Home button and keep the two buttons pressed for 10 seconds: (a) Hold the Power button on your iPhone down for 3 seconds: Step 5: You will now need to put your iPhone into the DFU mode. Step 4: You will now be prompted plug your iPhone to the computer and switch it OFF. Step 3: After launching Redsn0w, click on the Jailbreak button. Windows XP and Windows 7 users should run Redsn0w as ‘Administrator’ (right-click on the Redsn0w exe and select ‘Run as an Administrator’). Windows 7 users should run the exe in Windows XP compatibility mode (right-click on the Redsn0w exe and select Properties, then select the Compatibility tab and select Run this program in compatibility mode for Windows XP). Navigate to the Redsn0w folder and launch the Redsn0w application. Step 2: Double click the Redsn0w zip file and extract the application. Step 1: Download Redsn0w 0.9.15b3 (Redsn0w 0.9.15 beta 3) from this link and save the application in a folder named “ Redsn0w” on your desktop. You can follow these step-by-step instructions to jailbreak your iPhone 4 and iPhone 3GS on iOS 6: Please ensure you are running latest version of iTunes i.e.You can refer to this post for instructions on how to backup your iPhone using iCloud or this one to backup your iPhone using iTunes. Please do not forget to backup your iPhone before you proceed.Please note that jailbreaking your iPhone may void your warranty and hence proceed with caution and at your own risk.It is currently not possible to jailbreak iPhone 5 and iPhone 4S. Redsn0w 0.9.15b3 only supports a tethered jailbreak, which means that you need to connect your iPhone to the computer on every reboot (except iPhone 3GS with older bootrom).Warning: If you depend on Ultrasn0w to unlock your iPhone, then DO NOT update to iOS 6. iPod touch users can check out our step-by-step guide to jailbreak iPod touch using Redsn0w here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |